服务热线:
400-879-1999
联系我们
服务热线
400-879-1999
电话:400-879-1999
地址:山东省莱州市206国道与308省道交叉口东南50米
当前位置:首页 > 中科资讯 > 新闻资讯 > 混凝土搅拌机搅拌叶的安装注意事项
混凝土搅拌机搅拌叶的安装注意事项
来源:http://www.cnzkjf.cn发布日期:2020-07-08   浏览量:
 
一:安装注意事项
1: Installation precautions
1.混凝土搅拌机的搅拌叶的倾角要一致,不能装反;
1. The inclination angle of the mixing blade of the concrete mixer should be consistent and can not be installed in reverse;
2.搅拌叶倾角过大或过小都会影响搅拌产量,所以叶片与搅拌轴线的倾角在70度或80度左右即可;
2. Too large or too small inclination angle of the mixing blade will affect the mixing output, so the inclination angle between the blade and the mixing axis is about 70 or 80 degrees;
3.搅拌叶的较佳角度是旋转至上部露出泥料20-30mm;
3. The better angle of the mixing blade is to rotate the upper part of the blade to expose the mud 20-30mm;
4.两根轴上搅拌叶的相位应与漆相对会在时的相位错开90度;
4. The phase of mixing blades on the two shafts should be staggered by 90 degrees from the phase when the paint is opposite to each other;
5.安装搅拌叶时一定要上紧,应尽量上紧搅拌叶上的头一个螺母;
5. When installing the mixing blade, be sure to tighten the first nut on the mixing blade as much as possible;
中科混凝土搅拌车
二:修理
2: Repair
混凝土搅拌机搅拌叶损坏主要原因有:
The main reasons for the damage of mixing blades of concrete mixer are as follows:
1.叶片磨损,这时候需要割炬把叶片磨损的边缘斜口割齐,然后用和叶片厚度相同的钢板切割成需要的尺度补焊到叶片残体上;
1. The blade is worn. At this time, it is necessary to cut the beveled edge of the worn blade with the cutting torch, and then use the steel plate with the same thickness as the blade to cut into the required scale and weld it to the blade residue;
2.叶柄弯曲或折断,造成这两种情况的原因有:
2. The petiole is bent or broken, which is caused by the following reasons
(1)叶柄强度不够,这时加大叶柄直径,用圆钢加工;
(1) When the strength of petiole is not enough, the diameter of petiole should be increased and processed with round steel;
(2)叶柄材质较脆,这时可改为普通圆钢。
(2) The material of petiole is brittle, so it can be changed into ordinary round steel.

Copyright @ 2020 莱州中科聚峰机械有限公司 All Rights Reserved. 版权所有
电话:15098551508 地址:山东省莱州市206国道与308省道交叉口东南50米
聚峰机械专注生产销售自动搅拌车、自动搅拌机,厂家直销,型号齐全,经久耐用,质优价廉;以规范的管理为依托,以专业的技术为支持,安全可靠,让您放心选择!