The transmission of automatic feeding mixer is also a very important part. In the transmission process, how should we detect the oil level and oil quality?

在进行传动检查或故障诊断之前，应进行传动油位和油质检查。把齿轮选择处理在P的位置,发动机将闲置少几分钟运行,石油达到正常的工作温度,车必须停在路的水平,以确保微分和传输之间的油位高度是正常的和稳定的。

Before the transmission inspection or fault diagnosis, the transmission oil level and oil quality should be checked. If the gear is selected and processed at the position P, the engine will be idle for at least a few minutes, the oil will reach the normal operating temperature, and the car must be stopped at the road level to ensure that the oil level between differential and transmission is normal and stable.

带油位尺自动变速器油位检查的具体方法如下:

The specific methods for oil level inspection of automatic transmission with oil level gauge are as follows:

1. 将自动上料混合机置于水平地面上，拧紧手刹。

1. Place the automatic feeding mixer on the horizontal ground and tighten the handbrake.

2. 让发动机空转几分钟。

2. Let the engine idle for a few minutes.

3、踩下制动踏板，控制手柄向后退、前进等位置，并在每个位置停留几秒钟，使液力变矩器和所有换档执行机构都充满液压油。，将控制手柄推到停止位置。

3. Step on the brake pedal, control the handle to backward, forward and other positions, and stay in each position for several seconds, so that the hydraulic torque converter and all shift actuators are filled with hydraulic oil. Finally, push the control handle to the stop position.

4、从油管中取出自动变速器上的直尺，将清洗干净的所有直尺放入油管中，然后拔出，检查标尺上的油位高度。

4. Take out the ruler on the automatic transmission from the oil pipe, put all the cleaned rulers into the oil pipe, and then pull it out to check the oil level on the ruler.

以上是自动上料搅拌机变速器油面和油质检测方法，如有仍不明白的问题欢迎来电咨询详情。

The above is the automatic charging mixer transmission oil level and oil quality detection methods, if you still do not understand the problem, please call for details.