中科聚峰搅拌车是特殊的重型卡车，当油箱搅拌时具有高有用载荷，复杂的道路条件和大的惯性离心力，这对混凝土自动上料搅拌车系统的制动系统提出了很高的要求。尽管制动系统对于混合器系统非常重要，但确定中科聚峰搅拌车性的首要考虑因素是车辆的制动距离和制动器的热劣化。

Zhongke Jufeng mixer truck is a special heavy truck, which has high useful load, complex road conditions and large inertial centrifugal force when mixing with oil tank, which puts forward high requirements for the brake system of automatic concrete feeding mixer truck system. Although the braking system is very important for the mixer system, the first consideration to determine the safety of Zhongke Jufeng mixer is the braking distance of the vehicle and the thermal degradation of the brake.

如果搅拌车的制动系统出现问题，驾驶员和乘客也会面临风险。因此，在驾驶或踩刹车时需要注意制动。

If there is a problem with the brake system of the mixer, the driver and passengers will also face risks. Therefore, you need to pay attention to braking when driving or braking.

1，制动时噪音异常

1. Abnormal noise during braking

当您踩下制动器时，制动系统会产生尖锐而严重的金属摩擦。这可能是由于刹车片中的异物，刹车盘上的锈蚀等。

When you step on the brake, the brake system will produce sharp and severe metal friction. This may be due to foreign matters in the brake pads, rust on the brake discs, etc.

2，制动踏板行程变长

2. The brake pedal stroke becomes longer

当刹车变软时，你会看到一个直的白点。制动行程长的原因主要是由于空气进入制动系统，制动油不足，可能的泄漏以及制动衬块的严重磨损。

When the brakes soften, you'll see a straight white spot. The long brake stroke is mainly due to air entering the brake system, insufficient brake oil, possible leakage and serious wear of brake pads.

3，制动偏差

3. Braking deviation

制动偏差现象不太常见，主要反映了当施加制动时方向盘偏向一侧的事实。这种现象的原因可能是制动衬块的偏心磨损和制动气缸的问题。

The phenomenon of brake deviation is not very common, which mainly reflects the fact that the steering wheel deviates to one side when braking is applied. This phenomenon may be caused by eccentric wear of brake pad and brake cylinder.

4，刹车变得越来越困难

4. Braking becomes more and more difficult

许多搅拌车伴随着增强制动的问题。加强制动器的主要原因是真空助力器失效。制动器没有辅助，经常使用制动器。

Many mixers are accompanied by the problem of enhanced braking. The main reason to strengthen the brake is the failure of vacuum booster. The brakes are not assisted and are often used.

5，制动器反弹

5. The brake rebounds

有许多搅拌车合作伙伴遇到过这种情况，但是当施加制动时，存在上肢弹回制动踏板的现象，这主要是由于制动盘表面的不规则性。垫子和钢圈的变形。

Many mixer partners have encountered this situation, but when the brake is applied, the upper limbs spring back to the brake pedal, which is mainly due to the irregularity of the brake disc surface. Deformation of cushion and steel ring.