The concrete mixer truck is also called cement mixer truck, mixing tank truck, commercial mixer truck, snail truck, etc. It is called differently according to different regions.

在我国生产的混凝土搅拌车的底盘多采用整车生产厂家提供的二类通用底盘，其专用机构主要包括取力器、搅拌筒前后支架、减速机、液压系统、搅拌筒、操纵机构，清洗系统等。那么，混凝土搅拌车选购要点有哪些呢？下面富鑫汽车为您介绍。

The chassis of concrete mixer trucks produced in China are mostly Class II general chassis provided by vehicle manufacturers, and its special mechanisms mainly include power take-off, front and rear supports of mixing drum, reducer, hydraulic system, mixing drum, operating mechanism, cleaning system, etc. So, what are the key points for the purchase of concrete mixer? Now let's introduce Fuxin Automobile to you.

选购要点一：使用要可靠

Key point 1: reliable use

混凝土装入车内以后，要求在2h或更短的时间内卸到工作面上，在此期间不停地搅拌。如果在规定时间内不能运到工地或因各种原因停止搅拌，车内混凝土就会报废，严重的会导致混凝土凝固在车内，造成搅拌运输车报废。这对搅拌运输车的可靠性提出了严格的要求，不允许搅拌运输车在工作时发生停机的故障。因此混凝土搅拌车选型要考虑的就是车辆十分可靠，关键部位如发动机和传动一驱动装置发生故障的可能性要越低越好。

After the concrete is loaded into the truck, it is required to unload it on the working face within 2h or less, and mix it continuously during this period. If the concrete cannot be transported to the construction site within the specified time or the mixing is stopped for various reasons, the concrete in the truck will be scrapped, and in serious cases, the concrete will solidify in the truck, causing the scrapping of the mixer truck. This puts forward strict requirements for the reliability of the mixer truck, and does not allow the mixer truck to stop when it is working. Therefore, the first thing to consider in the selection of concrete mixer is that the vehicle is very reliable, and the probability of failure of key parts such as the engine and transmission drive device should be as low as possible.

选购要点二：装载量要合适

Key point 2: The loading capacity should be appropriate

理论上说，运输车辆的装载量越大，运输效率越高，但这也会导致车辆购置成本直线上升和通过性下降。装载量为8～9m。8×4底盘的混凝土搅拌车要比装载量为6～7m。6×4底盘的贵309/5～40%，同时，建筑工地一般地域狭小，临时施工道路路况很差，大车尤其是半挂车行动不便的问题充分考虑到。因此，确定车辆的装载量时一定要综合考虑各方面的因素，不可顾此失彼。

In theory, the greater the loading capacity of transport vehicles, the higher the transport efficiency, but this will also lead to a straight-line increase in vehicle acquisition costs and decline in trafficability. The loading capacity is 8~9m. eight × 4 The specific loading capacity of concrete mixer truck with chassis is 6-7m. six × 4 The price of chassis is 309/5~40% higher. At the same time, the construction site is generally small, and the temporary construction road is in poor condition. The problem of inconvenient movement of large vehicles, especially semi trailers, should be fully considered. Therefore, when determining the loading capacity of the vehicle, all factors must be taken into account comprehensively.

选购要点三：混凝土贮罐及进、出料口要耐磨

Key point 3: the concrete storage tank and the inlet and outlet shall be wear-resistant

沙和砾石是混凝土的主要组成成分。它们使混凝土贮罐及进、出料口在工作时磨损严重。一般情况下，采用低合金钢制造的混凝土贮罐使用寿命为5～8万m。混凝土贮罐内的螺旋叶片寿命只有3～4万m。。国产混凝土贮罐一般由高强度低合金钢钢材制成，比普通A3钢材耐磨提高1～2倍。一些进口混凝土贮罐采用锰硼专用耐磨钢材，并且在易磨损部位镶耐磨材料加固，因此其使用寿命比低合金钢制造的又可提高1倍。由此可知，采用材料不同其工作寿命则大不相同。

Sand and gravel are the main components of concrete. They make the concrete storage tank and the inlet and outlet wear seriously during operation. Generally, the service life of concrete storage tank made of low alloy steel is 50000~80000 m. The service life of spiral blades in concrete storage tanks is only 30000~40000 m.. Domestic concrete storage tanks are generally made of high-strength low-alloy steel, which is 1~2 times more wear-resistant than ordinary A3 steel. Some imported concrete storage tanks are made of manganese boron special wear-resistant steel and reinforced with wear-resistant materials at the easily worn parts, so their service life can be twice as long as those made of low alloy steel. It can be seen from this that the working life varies greatly with different materials.

选购要点四：机构设计合理，操作方便，混凝土贮罐卸料彻 底

Key point 4: reasonable mechanism design, convenient operation, complete unloading of concrete storage tank

这些使用中经常遇到的问题也考虑到。比如若卸料不完全，留在罐内的混凝土就会越积越多，使贮罐容量减小，并且清理十分困难。

These problems often encountered in use are also considered. For example, if the unloading is not complete, the concrete left in the tank will accumulate more and more, reducing the tank capacity, and it is very difficult to clean.

选购要点五：售后服务要好

Point 5 of purchasing: better after-sales service

混凝土搅拌车是一种专用重型车辆，保有量少，配件来源少，与一般通用汽车相比，对厂家的售后服务依赖性较大。因此，厂家是否能提供方便快捷可靠的售后服务，是选型中考虑的重要因素。

The concrete mixer is a special heavy-duty vehicle, with less inventory and less spare parts. Compared with general motors, it is more dependent on the manufacturer's after-sales service. Therefore, whether the manufacturer can provide convenient, fast and reliable after-sales service is an important factor to be considered in the selection.

选购要点六：要合理

Key point 6: reasonable price

在满足上述要求的前提下再考虑因素。装载量为6～7m后双桥底盘的混凝土搅拌车是性能比较高的车型，装载量为10～12m的半挂车次之，装载量为8～10m8×4底盘的性能比低。因此一般选用6～7m的混凝土搅拌车。另外，为满足个别大型工程的需要，可适当配少量10～12m的半挂车。这样可以兼顾各种需要，是比较合理的配置。

The price factor shall be considered on the premise of meeting the above requirements. The concrete mixer truck with 6-7m rear double axle chassis has high performance and price, followed by the semi-trailer with 10-12m loading capacity and 8-10m8 loading capacity × 4 The performance price ratio of the chassis is low. Therefore, 6-7m concrete mixer truck is generally selected. In addition, in order to meet the needs of individual large projects, a small number of 10~12m semi trailers can be appropriately allocated. In this way, various needs can be taken into account, which is a more reasonable configuration.

以上就是为大家介绍的有关全自动上料搅拌车的详细的介绍,希望对您有所帮助.如果您有什么疑问的话,欢迎联系我们.我们将以的态度,为您提供服务http://www.shanqijituan.cn/

The above is a detailed introduction to the fully automatic feeding mixer, and I hope it will be helpful to you. If you have any questions, please contact us. We will provide services for you with our attitude http://www.shanqijituan.cn/