I believe that with the use of some Zhongke Jufeng agitators, the enterprise knows that there will be some sudden failures in the long-term use of the equipment, so how to clean the materials when the equipment fails to operate normally? Let me introduce to you.

　　1.准备好应急驱动软管，关闭搅拌器，拆卸液压马达上的高压油管接头。

　　1. Prepare the emergency drive hose, close the agitator, and remove the high-pressure oil pipe joint on the hydraulic motor.

　　2.关闭救援车，取下其液压马达高压油管，将应急驱动软管与故障车辆相应接头连接。

　　2. Close the rescue vehicle, remove the high-pressure oil pipe of its hydraulic motor, and connect the emergency drive hose with the corresponding joint of the failed vehicle.

　　3.启动救援车，将其控制手柄移动到卸料位置，故障车辆内的混凝土将被卸料。

　　3. Start the rescue vehicle, move its control handle to the unloading position, and the concrete in the failed vehicle will be unloaded.

　　4.紧急驱动完成后，拆卸驱动软管，恢复两辆车的原始状态。

　　4. after the emergency drive is completed, remove the drive hose and restore the original state of the two vehicles.

　　除上述方法外，在自动上料混合机的支承轮与滚道之间放置一个木楔，以控制混合筒的转动。关闭发动机，拆下液压马达的高压油管，混合器可以自由旋转，控制混合器的旋转，使修补孔向底部，然后打开修补孔，桶内的混凝土。此时一定要注意，混凝土排出后，混合器的原始状态。

　　In addition to the above method, a wooden wedge is placed between the supporting wheel and the raceway of the automatic feeding mixer to control the rotation of the mixing cylinder. Shut down the engine, remove the high-pressure oil pipe of the hydraulic motor, the mixer can rotate freely, control the rotation of the mixer, make the repair hole toward the bottom, then open the repair hole, and remove the concrete in the barrel. At this time, pay attention to the safety. After the concrete is discharged, the original state of the mixer shall be observed.

　　以上是中科聚峰厂家为大家介绍的相关内容，想要了解更多内容，欢迎访问网站：http://www.cnzkjf.cnThe above is the relevant content introduced by Zhongke Jufeng factory. To learn more, please visit the website: http://www.cnzkjf.cn